How To Attach Vinyl Siding To Concrete Block

There are hundreds of colors to choose from when you decide on installing vinyl siding.

How to attach vinyl siding to concrete block.

Place the strip so its center is lined up with the vertical line. That s a good question david. Talk to the folks at the big box store near you. Line up the hole in the strip with the top hole you drilled in the wall.

Insert a sleeve anchor into this hole and tighten the anchor enough to hold the furring strip in place. This will allow the vinyl to contract and expand with changes in the weather. You want to nails these in to the block joint not the block itself. In effect i would need to add a bit of spacing between the concrete and the siding.

The contractor proposed using tapcons to attach the siding directly to the foundation which would allow the siding to line up with the first floor. At the top of a furring strip drill a hole. Vinyl siding is a great material to dress up a concrete block structure. Cut preformed vinyl corners to the measurement and attach them to the furring strips you installed on the block wall corners.

The first one i can think of is ackerman johnson aj s but there are other brands too. My initial thought was to attach whole sheets of 1 2 osb around the portions i want to add siding to directly to the concrete using concrete anchors. The most secure method to install siding on blocks is to screw it on. There are several brands of screws that require a very small hole to be drilled and then they can be screwed directly into the blocks.

And the vinyl siding institute actually recommends that when you are applying vinyl siding over concrete block walls that you do use a furring strip of at least inch thick. Furring strips are basically 1x3 or 1x4 strip of wood that are vertically nailed every 16 inches on center using masonry or concrete nails. Easiest and only way to install vinyl siding over the cinder block wall is to nail on something called furring strips. Vinyl siding colors are not restricted to the limited five or ten pastel colors that were the choice for so many years.

Nail the siding strip into place with small nails leaving 1 8 inch of the nail shank showing. Position the first piece of vinyl siding against the furring strips at the top of the wall. As a result the osb protrudes about a half inch farther out than the concrete.